9
8
7. FILM LOADING & THREADING
1.Slightly slide the shaft to the right and pull it out
from the machine.
?
?
?
?
?
?
?
?
?
?
?
?
@@
?
?J@@L?hg?
?7@@1?hg?
J@@@@Lhg?
7@@@@1hg?
?J@@@@@@L?hf?
?7@@@@@@1?hf?
J@@@@@@@@Lhf?
7@@@@@@@@1hf?
?J@@@@@@@@@@L?he?
?7@@@@@@@@@@1?he?
J@@@@@@@@@@@@Lhe?
@@@@@@@@@@@@@@he?
?
?
?
?
?
?
?
?
?
?
LOADING UPPER ROLL FILM
2.
Take both lock core adapters off of the shaft
3.Insert one of the core adapters into the right end
of the film core. For film w
i
th poly-in (adhesive
side is inside the web), make sure the adhesive
side is facing upward.(Fig.3)
1. Turn the laminator ON (I) located on the rear of the machine. (Fig. 1)
2. Choose appropriate laminating thickness and speed.
3. Do not begin laminating until the blinking light is steady (approximately 10 minutes).
4. Position the item to be laminated on the feed table.
5. Press the RUN button. The rollers will begin to turn, wait for heat line to disappear,
feed the item into the machine.
6. Stop the laminator when all of the items have completely exited the rear of the
machine.
Repeat the above steps until all of your lamination is completed. When lamination is
completed or the machine is not in use for an extended period of time turn the power off.
NOTE: Stand by mode and auto power off mode
- Stand by mode: If no activity is made within 30 minutes after each use the machine
will automatically switch into stand by mode. (In stand-by mode the temperature will
decrease to 80~90°… (176~194°F) and the three film thickness setting indicators will
blink).
- Auto power off mode: If the machine is in stand by mode and no activity is
made for 60 minutes the machine will automatically power off.
- If any activity is made while in stand by or auto power off mode the machine
will return to it's previous settings.
RSL-380
Figure 1
Figure 2
Figure 3
