RSL-2700
7
CONTROL PANEL
POWER
When connected the power , the light will always be on.
TEMP.
1.5 mil : To laminate film thickness of 1.5 mil (230˚F~270˚F)
3.0 mil : To laminate film thickness of 3.0 mil (270˚F~310˚F)
* When the machine is ready , the light will be always on.
working temperature may vary depending on the film manufacturer.
If laminating comes out cloudy, then select the higher temp. setting.
REVERSE
To reverse the rollers
RUN / STOP
To start or stop rollers
Note:
After ready, if no activity is made within 30min after each use, the machine will
automatically switch into stand-by mode (Temperature will automatically reset to
176°F (80°C).
LOADING FILM
< Thermal Film Loading & Threading >
Loading Film
1. Remove the upper and lower film shafts from the
machine and load the films (do not tighten the core
screws at this time)
Figure 1
2. To load the top film, insert 1" core as shown on
Figure 1 (Note the direction that the film is wound)
3. Insert the shaft as shown in Figure 2.
Figure 2
4. Insert the core plug on the left hand side. (Figure 3)
Figure 3
5. Align and center the film and tighten the two core
screws. (Figure 4)
Figure 4
6. Repeat steps 2 through 4 to load the lower film.
(Please note the direction that the film is wound
for the bottom roll). (Figure 5)
Figure 5
7. Load the upper and lower film shafts on the machine.
* When loading 27" film on the lower, be sure to insert
the film core deeply into the film roll core to provide
room at each end.
