RSL-382CR / 2702CR / 1062CR
13
1. Turn on the power switch located on the rear of the machine.
2. Set the pressure lever to the "Laminating mode".
3. Increase the roller temperature. If you already have a setting in the memory that
you want to use press the button and then the or buttons to
select your desired setting.
4. When the desired temperature is met "READY" will be displayed on the screen and
you will hear a beep.
5. Press the button. The rollers should begin to turn, if they do not turn make sure
the safety cover is closed or check the troubleshooting section of the manual.
6. Use the upper and lower Tension knobs to properly adjust the tension of the roll film.
Having the tension too tight will slow down or prevent the rollers from turning and if
the tension is set too low this can cause wrinkles in your lamination.
7. For ease and convenience set the document guides in position.
8. Set document on the table. You should allow at least 5mm(1/4") space on each
side for perfect lamination.
9. Press the button when lamination is competed.
10. Turn on the switch in the right cover of rewinder device if you want to wind the
finished lamination. That you can control the rewinder device by the switch only
when the machine is in running state.
11. When lamination is completed your item may be hot and can easily bend. Lay on a
flat surface to properly cool.
12. When you have completed all of your lamination, set the pressure lever to the OPEN
position.
13. Turn the Power switch off.
9.1. HOT LAMINATING
9. LAMINATING STEPS