4.1 Adjusting Take-Up Shaft Speed
1. Main rollers and Take-Up Shaft speed is not synchronized.
1. Take out the Take-Up Shaft Cover by loosing three screws. Figure 1
2. Use a 11/16" (17mm) wrench to loosen (increases speed) or tighten (reduces speed) the bolt. Figure 2
4.2 Adjusting Front Roller
7.2)
RSC-
30 ~ 36
37 ~ 42
on the gauge
when the machine is running, check that
the top and the bottom films are fed in
without any wrinkles.
CAUSES:
MEASURES:
Pressure
• Use 5/16” or 8mm Allen wrench
to adjust the roller pressure:
Clockwise – Increase pressure.
Counter Clockwise – Decrease pressure.
1. Using Push-Pull Scale , measure
4. Check above steps 2 through 3 with
5 spots as shown on Figure B &C:
Front roller should read between 2-3
2. Checking for over all tension –
4. Adjustments
with different thickness of substrates.
3. Laminating Test – Laminate samples
1.5mil & 5mil films.
Figure 1
Clockwise
Counterclockwise
Figure A
Figure B
Figure C
Decrease
Increase
Figure 2
1
Содержание RSC-165C
Страница 19: ...CHANGING REMARK No Part No Part Name Spec Qt y 5...
Страница 41: ...8...