RSC-1401/1651HCLTW
11
Figure 1
1. Lay the decaled image face down on a flat surface. Carefully
peel back and put a crease along the edge of the release liner
(Approximately 1 inch or 25mm, Figure 1).
2. With the image facing up, align the image onto the board. Press
firmly from the center out (Figure 2).
3. Adjust the pressure lever to ensure the proper opening (Figure
3).
4. Flip the image over the upper roller and hold on to the release
liner (Figure 4).
5. Press the foot pedal once, and then let it go while slowly pulling
the release liner as the board enters the main roller nip (Figure
5).
Press the foot pedal once again when the board has completely
exited from the rear of the unit.
Trim the board if necessary.
Figure 2
Figure 3
Figure 4
Figure 5
10.2 Mounting