7
7. ROLLER NIP SETTING
It is important to adjust the roller nip settings to the appropriate thickness of the board being used. Use the
guide below to adjust to the correct position.
8. USING FOOT PEDAL AND REMOTE CONTROL
USING FOOT PEDAL
Whether the RUN button is set to the on or off position,
roller operation may be controlled by using the foot pedal.
NOTE:
When not laminating and the rollers
are not moving, it is recommended the pressure
1
2
3
4
5
6
7
NO.
Inches
Metric
(mm)
1
Lamination
Lamination
2
1/25
˝
1
3
3/6
˝
~1/4
˝
5~7
4
3/8
˝
~1/2
˝
10~13
5
3/5
˝~
18/25
˝
15~18
6
4/5
˝
~3/25
˝
20~23
7
1
˝
25
lever be set to the OPEN position to prevent
flat spots from forming in the rollers at the point
where the upper and lower rollers make contact.
If the rollers are not turning and the foot pedal is depressed
one time, the rollers will begin turning. And if the rollers are
turning, depressing the foot pedal one time will stop the
rollers from turning.