12
11
RSC-1400L
Figure 3
8. Cut and separate the release liner and the film.(Figure
3)
9. Thread the craft paper behind the Lower Idle Bar to
the top film that is resting on the main roller (do not
use the Lower Idle Bar for Mounting). (Figure 4)
10. Reinstall the Feed Table and the Frame-Paper
Guide,and close the Safety Cover.
11. Adjust the nip setting to appropriate gap.
12. Insert and push the leader board until they reach the
front nip point.
13. Push the Run button.
14. Push the leader board into the rollers. (Figure 5)
15. Adjust the top and bottom tension knob by rotating it
clockwise or counterclockwise. Turn it until the top
and bottom roll films have some resistance varies
(the tension depending on the film thickness; the
thicker the film the more tension is required).
(Figure 6)
Figure 4
Figure 5
Figure 6
11. THREADING FILM
Figure 1
Figure 2
11.1. Decaling
1. Turn the power switch on (“I” position). The Power
switch is located on the rear left side of the unit.
2. Complete the steps as in the “LOADING FILM”
section (see page 10).
3. Take off the Frame-Paper Guide and the Feed Table.
4. Pull the top film down over the Safety Cover to the
bottom of the craft paper / Mounting film.
5. Align and center the craft paper / Mounting film to the
top film and tighten the two lower core screws (Figure
1).
6. Thread the top film underneath the Upper Idle
Bar.(Figure 2)
7. Tape the top film on to the Release Liner Take-
Up.(Figure 2)
