7
PRODUCT OPERATION
(CONTINUED)
MAINTENANCE OF THE MACHINE
WARNING: Before dusting or cleaning, turn the power switch off and disconnect the power cord from the
machine. It is very important to clean all the sensors in the machine with a soft brush to avoid any paper
particles or dust from sticking to the light transmitter or the light-receiver sensors. It is important to clean
the inside of the machine occasionally. Unplug the machine and lift the top cover to gain access to the
interior.
If necessary, the glass surfaces of the detectors may be wiped with a soft cloth damped with alcohol.
To get the best results out of your bill counter, Royal Sovereign recommends using
Royal Sovereign
Cleaning Cards (RBC-CLN)
to remove dirt, dust, oils, and other contaminates from bill counters. With the
machine on, simply run the cleaning card through the machine like a bill. This cleaning card will run through
and clean the sensors of dirt and other contaminates. Cleaning cards are recommended to be used after
every 100 cycles.
•
Auto and Manual Start Modes:
Select the “MNL” button to flip between Auto and Manual
start. In Manual mode, insert the bills into the hopper, and select “START” to begin counting.
•
Batch Mode
: The machine is preset to common counting mode, which automatically counts
all bills placed into the hopper. To count bills in batches, press the “BATCH” button. The
batch count amount will automatically start at 100.
•
Press the “BATCH” button again to set the amount to 50.
•
Press the “BATCH” button again to set the amount to 20.
•
Press the “BATCH” button again to set the amount to 10.
•
Press the “BATCH” button again to set the amount to 1.
•
Press the “BATCH” button again to turn the batch mode off.
•
Use the “
+
” and “
-
” buttons to increase and decrease the quantity by 1.
3. Place bills into the hopper to begin counting.
