RDHC-150P
PRODUCT VIEW
-4-
FRONT
BACK
Control Panel
Top Panel
Filter - located
behind air inlet
grid/panel
Inlet grid
Door
Support Base
Drain Hose
Handle
Wheel
Warm Air Outlet /Exhaust
Cord Wrap
Handle
Front Support Frame
INSTALLATION AND ASSEMBLY
1. Your dehumidifier is designed for easy use and maintenance. Make sure that the filter is properly installed before use.
2. Keep the unit’s air inlet and outlet at least 24” (61cm) away from any wall/ obstruction.
3. Select a flat, stable surface to place the unit. Do not place on or near heat sources such as stoves, radiators, heaters and avoid placement in direct sunlight.
4. Do not operate the unit in areas where chemicals are stored. Volatile chemicals might damage the unit and may cause the water bucket to leak.
Note
: Do not tilt the unit over 45° to avoid damaging the compressor.
AUTO PUMP HOSE INSTALLATION
** This Commercial Dehumidifier has a Built-in Auto Pump, which allows water removal of up to 5m (16.4ft) in height.
You can therefore run the supplied hose to a drain, sink, etc.
1. Connect the supplied 5m hose to the dehumidifier. Refer to water pump connection diagram.
2. Run the hose to the desired drainage location. Ensure that there is no kinks or knots in the hose.
Water-pump connection
