7. How to install the radio and batteries
Glue the servo holder plate in the fuselage and install the control servo close to the servo holder
plate. Make an opening for the RC receiver switch and install it. Insert the battery and the
receiver into the fuselage. Use foam to protect them from vibrations and impacts. Connect all
components as necessary. Use a Y harness to connect the aileron servos to one channel only or
use two channels for ailerons, if available.
8. Finishing the model
The wing halves can be secured in the right position either by self-adhesive tape or using a
rubber ring. In this case make 1.8 mm holes in the first wing ribs and screw in the hooks for the
fixing rubber ring. Drill the holes in the proper position in the fuselage for the rubber ring. In
case of using this model for thermal soaring, attach the tow hook
Applying the decorative stickers is the last step to finish your model.
FLYING
Check the centre of gravity position (75-80 mm),
add some lead if necessary, don`t forget to
check the symmetry of the whole model. Once on the field, first check the function of your RC
set and check the range, too. Calm wheather is the best for the first flights. Try hand launching,
trim if required for optimal gliding. Provided that everything is in order, you can go for the
maiden flight, with a charged battery of course.
Fluctuations recommended (in mm terminal bow for ailerons, clacks and elevator)
Ailerons : +14 -6. Elevator : + 5 -4. Rudder : 32 et 32.
Centrage : from 75 to 80 mm from the leading edge for the first flight and move it back to your
liking.
Have a lot of fun and many happy landings with your DG-300.
