9
normal,
will be shown. When water temperature higher or the same as the temperature your setting, it will be non-work
(constant temperature).
Will be shown.
During constant temperature, water temperature must be 2°C lower than the
temperature your setting then can be work again.
Temperature set: Press
press
or
can adjust the temperature.
The range of temperature setting:
20°C-45°C
The range of temperature show:
10°C-50°C
Warning of excess temperature: When water temperature higher than 50°C, LCD shows "HEAT"
5)
Air bubble function: Press air bubble
can start or close it. When start LCD will show dynamic digital display
.
After 60mins will be closed by automatically.
6) Underwater lamp function: Underwater lamp will start when start water pump.
(Display switch)
Also can press
to start or close it. When starts the LCD will show dynamic digital display
Press
for 2 seconds, LCD shows LOCK and
, means lock panel, or means unlock.
7)
O
3
function: press
can start or close it. When starts, LCD shows O
3
and lasts 30 mins then closed by automatically.
8)
Telephone function: When start the panel or during FM or AUX, if calling need answer to, FM or AUX will be closed, the
speaker ring, and LCD shows
, at the time, can press,
, the telephone key shows then can get through calling. After
calling then press Telephone key again, the FM or AUX will be recovered, LCD shows FM or AUX. If need call to anybody, just
need press Telephone key, then press the numbers shows in LCD is OK.
2.
Radio section:
1) Put the radio antenna in the right place, press FM radio switch
, LCD will show frequency of radio, the volume DB will be
increased from 0 to 08 DB., Speaker has little sounds.
2) Press
shows
, then press
or
choose channels. If press it over 2 seconds, frequency will up or
down by automatically, till get channels. If no good signal or bad condition, we advise choose channels by hands. If get good
channel please press memory key
. lt will show in
, means can keep that channel in this key, the most memory
channels are 20.
(Before keep channel memory must choose channle.or press
just up or down).
or
to choose channels
press
KEY.
The temperature you setting shows
Содержание B313
Страница 1: ...Installation and Operation Manual...
