Royal Enfield Classic 350 2009, Руководство по обслуживанию, Страница: 45 / 229

03-21
Periodical Maintenance
(B) CHECKING PROCEDURE OF
THROTTLE POSITION SENSOR
(TPS) CABLE
To achieve response from TPS ignition
timing
change over after 40% operation of rotor
grip following adjustment and placement
is recommended.
✰ After adjustment of throttle grip
free play, raise the throttle grip to “
FULL” position and observe TPS push
rod free movement.
NOTE:
Ensure following position of A, B, C TPS
cable outer nuts & bracket mounting X,
Y screws.
Slide the rubber boot, use 10 mm spanner
to adjust cable outer and lock the nut. Move
the rubber boot over the lock nuts.
2 to 3 mm
Step 1:
✰
Two nuts (A & B) shall assemble
outside the throttle guide bracktet
as showm in Fig.
A
B
C
Step 2:
✰ One nut (C) shall assemble inside the
throttle guide bracket at extreme left
position as shown in Fig.
Step 3:
✰
Throttle guide bracket screws (X &
Y) shall assemble with the throttle
switch body bracket at extreme right
position of the slots as shown in Fig.
A
B
C
(C) REPLACEMENT PROCEDURE
OF THROTTLE POSITION SWITCH
(TPS) ASSY.
While replacing TPS assy. following steps
are important to achive ignition timing
changing shall take place at 40% of
throttle opening to obtain more mileage
and reduced emissions.