4 2
WASHING PROCEEDURE
Rinse vehicle thoroughly with plain water
to remove the detergent and wipe vehicle
dry.
If possible, use compressed air and blow off
water particles from the obscure areas of the
vehicle, electrical connections, etc.
After washing
Ensure, the vehicle is thoroughly dry by
wiping with a clean soft absorbent cloth
or chamois leather.
Remove all plastic bags and adhesive tapes.
Lubricate control cables, pivot and rear chain
with lube oil
Polish the painted and plated surfaces using
polishing wax.
Start engine and allow to run at idling speed
for a few minutes to warm up engine.
Drive the motorcycle slowly, applying both
brakes intermittently to dry up the brake
shoes.
Test brakes for full efficiency.
Precautions
Wash vehicle when the engine is cold.
Cover the silencer, tail pipe, carburetor
and control switches with suitable plastic
bags and tie it firmly to prevent water entry
to them.
Remove ignition key and seal key hole using
adhesive tape.
Brush engine area with kerosene / diesel to
remove dirt or grease.
Use low pressure jet of water to clean the
vehicle or engine.
Never spray water with great force on head
lamp, speedometer, flasher lights, front and
rear wheel hubs, electrical connections and
wires, control cables, carburettor, sparkplug,
battery etc.
Do not apply kerosene or diesel on painted
parts or rubber parts.
Use luke warm water and mild detergent on
the painted components to remove dirt, etc.
Содержание 2006 Thunderbird TwinSpark
