SL08_Rev01
Work Instruction Template
Template Released 8 November 2018
Work Instruction: Install MTX Sound Bar (Aluminum)
Sound Bar Kit (P/N 1503AUA00031N)
CONFIDENTIAL DOCUMENT
© 2020 Mahindra Vehicle Sales and Service, Inc. All Rights Reserved.
ROXOR is a registered trademark of Mahindra Vehicle Sales and Service, Inc.
Page 2 of 3
3. If installing with a Bikini Top, position (2) bar clamps inward
of hook and loop flaps on Bikini Top. No modification are
required for Hard Top and Soft Cab Enclosure.
4. Install (2) supplied Mounting Blocks with a 5 mm Allen
wrench, position 3" (76.2 mm) from each end. For Bikini Top
only, position at 6.75" (171.5 mm) from each end.
5. Mark center of ROPS B-Pillar Cross Bar.
6. Roughly position Mounting Clamps in both directions from
center mark.
7. Hang Sound Bar on (2) Bar Mounting Clamps using (2) Hex
Head Shoulder Bolts.
8. Install (2) flat washers and (2) flange nuts, then tighten just
enough to allow for Sound Bar angle adjustments.
9. Adjust angle of Sound Bar. Do not angle more than 40° if
installing with a Soft Cab Enclosure. This is to prevent
interference with Rear Bow Assembly.
10. Torque (2) M6 fasteners to specifications.
