3. Back Slats
Secure the ten back slats to the back of the log store. Align each slat with the slats on the side panels and secure in place
using 2 x 40mm nails at each end of each slat. Nail the bottom back slat to the floor using an additional 3 x 40mm nail.
1. Wall Panels
Position the left side panel on the floor so that the frame sit on the floor and the cladding overhang the floor edge. Secure
through the bottom frame of the side panel into the floor using 2 x 50mm screws. Position and attached the right side
panel in the same way.
2. Shelf
Position the shelf at the desired height between the two side panels. Secure in place using 4 x 63mm screws. Screw
through the frame of the side panel in to the ends of the shelf frames as show below.
Drill
Drill
It may be necessary to
drill pilot holes for the
screws in this section.
It may be necessary to
drill pilot holes for the
screws in this section.
Important note:
The side panels slope down
to the back of the log store.
Note:
On the bottom slat, add an
additional three nails. Nail
through the board in to the
edge of the floor.
4. Roof Top Board
To the roof panel, position the roof top board so that it overhangs the front edge by 50mm. Secure in place using
6 x 30mm nails.
50mm
50mm
50mm
63mm
40mm
40mm
30mm
63mm
