Roverpet KK3, Руководство по сборке, Страница: 5 / 6

Roverpet
20 Kiji Dava Circle Prescott, Arizona 86301 800-658-5925 rover@roverpet.com
20.) Install the rings of the last remaining sheepskin pad, furry side up, over
the uprights and down onto the crossbars just installed. See the right
photo above.
21.) Install the last two remaining #23CBC crossbars into the highest set of
holes in the uprights to span across the longest faces of the assembly.
See the left photo below.
22.) Install the two #18TAC arms into the uprights and fully seat them. See
the right photo above.
23.) Set the two completed assemblies side-by-side and connect them
together by attaching the supplied #250 clips along the length of the
center frame pipes. Place five clips on the front and five on the rear of the
assembly. See the photos below.
24.) Attach the six supplied #FDC wall clips to the rear of the assembly as
show in the photos below.
25.) Select a wall location for the Roverpet #KK3 Cat Climber and attach it to
the wall with anchors (not supplied by Roverpet) which are appropriate for the
construction material of the wall. As an example, typical stud and drywall
Attach five
#250 clips
on both the
front and
back of the
assembly at
these
locations.
Attach FDC
wall clips
on backside
of assembly
at these
locations.