Rover 75 Saloon, Руководство пользователя

Страница: 109 / 285

Lights & Indicators
109
2
HEADLIGHT BEAM SPREAD ADJUSTMENT
Headlight beams are set during manufacture to conform to the
requirements of either left or right hand drive markets.
Owners of cars travelling to countries where it is necessary to drive
on the opposite side of the road, are required to adjust the beam
spread pattern of dipped beam headlights to avoid dazzling other
road users.
Cars with Halogen reflector-type headlights
Conversion of RH Drive headlights illustrated.
LH drive conversion symmetrically opposite
Use masking tape cut to size and affixed to the lens of both dipped
beam lights in the (darkened) segments shown in the illustration.
The markings on the lens will act as a guide. Alternatively, use a
proprietary masking kit or accessory of the type available at many
garages and service stations.
Cars with Halogen projector or Xenon headlights
These cars have an adjuster built into the light unit which can be
moved to adjust the beam spread pattern of the outboard dipped
beam headlights. The adjuster lever is located in the inboard light
unit on Xenon headlights and in the outboard light unit on
Halogen projector headlights and should be used as follows:
LH Xenon headlight illustrated
1. Remove the cover from the rear of the appropriate headlight.
2. Locate the lever inside the headlight unit and move the lever
to the alternative position from which it is currently set.
3. Remember to replace the headlight cover.
On return to your home country, remember to reset the lever to
its original position.
HB0317
HB0316