Rover 108 - 109, Руководство пользователя

Страница: 10 / 12

Rover Mowers Limited Ride-on Mower Grass Catcher Rover Mowers Limited Ride-on Mower Grass Catcher
Page 7 ii
5. MAINTENANCE
5.1 Cleaning the Grass Catcher
WARNING
The mower must be stationary with the
park brake applied, the engine switched
off and the ignition key removed.
1. Hose down the outside of the grass catcher
to keep it free of debris and any build-up of
grass or dirt
2. Open up the grass catcher and hose the
inside of the grass catcher to prevent any
build-up of dirt within the mesh of the grass
catcher. This could effect the free flow of
exhausted air from within the grass catcher.
5.2 Cleaning the Transfer Tube
5.3 General
1. After each day’s use, the ride-on mower
should be cleaned down. Paying particular
attention to the build-up of any foreign
matter around the air intake ports in the top
of the cutterhead and around the engine
exhaust pipe and muffler.
2. Check the condition of the safety instruction
decals on the grass catcher and the transfer
tube and replace any that become difficult to
read.
3. Inspect the grass catcher lining for signs of
wear and tear caused by the conditions under
which it is used. If and when a replacement
grass catcher lining is required, replacement
grass catcher linings are available from
Rover Authorised dealers and service agents.
CAUTION
Do not use any powder abrasive cleaners
or solvents (kerosene, petrol, etc.) to
clean the transfer tube as these scratch
and damage its clarity.
Wash out the inside of the transfer tube with a mild liquid
detergent and dry to maintain the transparency of the
tube.
SAFETY INSTRUCTIONS
Know your controls. Read the Owners Manual carefully. Learn how to stop the engine quickly in any emergency.
Do not allow children or people unfamiliar with these instructions to use the mower. Do not carry passengers.
Make sure the lawn is clear of sticks, stones, bones, wire and debris. They could be thrown by the blade.
Do not mow whilst people, especially children or pets are in the mowing area.
Never mow across the face of the slope, unless the mower is designed for this purpose.
Exercise extreme caution when on slopes.
Reduce speed on slopes and in sharp turns to prevent overturning or loss of control.
Do not stop or start suddenly when going uphill or downhill.
Stay alert for holes in the terrain and other hidden hazards.
Use care when pulling loads or using heavy equipment.
(a) use only approved drawbar hitch points
(b) limit loads to those you can safely control
(c) do not turn sharply
(d) use care when backing up, and
(e) use counterweight(s) or wheel weights when suggested in the owners manual.
Watch out for traffic when crossing or operating the mower near roadways.
Stop the blades rotating before crossing surfaces other than grass.
When using any attachments, never direct discharge of material toward bystanders nor allow anyone near the
machine while it is in operation.
Before leaving the operator’s position:
(a) disengage all clutches and secure cutting units
(b) change into neutral and set the parking brake, and
(c) stop the engine and remove the key.
Stop the engine and disengage the drive to attachments:
(a) before refuelling
(b) before making height adjustment unless adjustment can be made from the operator’s position
(c) before clearing blockages
(d) before checking, cleaning or working on the mower
(e) after striking a foreign object
(inspect the mower for damage and make repairs before restarting and
operating the equipment) and
(f) if machine starts to vibrate abnormally (check immediately).
Disengage the drive to the attachments when transporting or not in use.
A mower operator should be in good physical and mental health and not under the influence of any drug or alcohol
which might impair vision, co-ordination of judgement.
Never mow while barefoot or wearing open sandals or thongs. Wear long trousers and heavy shoes.
It is advisable to wear suitable eye protection when operating a mower.
Mow only in good daylight.
Before using, always visually inspect to see that the blades, blade bolts and cutter assembly are not worn or damaged.
(Replace worn or damaged blades and bolts in sets to preserve balance).
Check all nuts, bolts and screws often. Always be sure the mower is in a safe operating condition.
Keep safety devices (guards and switches) in place and in working order.
Never use the mower unless the grass catcher or guards provided by the manufacturer are in position.
Ensure that any spare parts used comply with the original manufacturer’s recommendations and specifications.
Replace worn or faulty silencer.
Keep engine free of grass, leaves or excessive grease. These can be a fire hazard.
Refuel outdoors only. Do not smoke while refuelling engine. Never remove the cap of the fuel tank or add petrol
while the engine is running or the engine is hot. Remove the fuel cap slowly to relieve any tank pressure. If petrol is
spilled, do not attempt to start the engine but move the machine away from the area of the spill and avoid creating
any source of ignition until the petrol vapours have dissipated.
Check for fuel leaks while refuelling or using the mower. If a fuel leak is found, do not start or run the engine until
the fuel leak is fixed and spilled fuel is wiped away.
Do not operate the engine in a confined space where exhaust fumes (carbon monoxide) can collect.
Always mount the mower on the opposite side to the discharge chute.
Stop the engine whenever you leave the mower, even for a moment.
Store the mower in a well ventilated room away from naked flames such as may be found in hot water heaters.
Do not lend or sell the mower without the Owner’s Manual.
WARNING
Damaged Blades and Worn Bolts
are Major Hazards
2664 Ride on Mower Grass Catch 22/5/06 2:31 PM Page 3