X935-25-00 Rev 1110 V894CSH High-Security Cameras
Installation
•
5
Camera/Lens Adjustments
After all cabling is complete, the camera and lens can be adjusted. The camera/lens is set through an OSD
menu system using a joystick control.
Figure 6
Camera Control Joystick
Camera Settings
There is a joystick control along the rim of the camera that is used to enter the OSD for camera settings. This
is used to navigate the OSD for camera setup. The analog camera must be connected to a portable (local)
monitor to use the menu system; the IP version can see the menus on the PC monitor. Use the cable
included in the accessory kit to connect the spot monitor. Refer to Figure 6.
Pressing the joystick down (Center) accesses the menu mode and confirms settings. Push the Center key for
3 seconds to access the Main menu. From there, using the joystick, select the feature to be programmed.
Moving the joystick up or down chooses the desired menu selection. Moving the joystick to the right or left
chooses the desired menu feature adjustment. (Right direction is marked.) A
"
indicates submenus.
Below is a summary of the OSD screens for camera setup of the day/night version. An explanation of the
individual screens follows.
2
nd
Video Connector
Joystick
UP
DOWN
RIGHT
LEFT
CENTER
RS-232 Serial
Connection
Camera
Connection
