Special care should be exercised in the handling, storage and installation of Roughneck HD equipment. The actual weight
of each piece of equipment will vary depending on style and model. The weight of the equipment is sufficient in volume
to warrant special care, assistance and in some instances the use of mechanical equipment during the transfer and
installation of the equipment. Do not assume a position directly under the equipment during installation. Be sure the
equipment has been connected and stabilized during installation to prevent falling or shifting of positions. Periodically
check tightness of bolts to make sure they are tight and unlikely to fail.
INSTALLATION INSTRUCTIONS
PART# BFERF15LD
FRONT BUMPER REPLACEMENT: FORD F-150: 2015-UP
Warning:
Installation of a front bumper on a truck with adaptive cruise will cause the adaptive cruise to not
function correctly. Please inform end user prior to installation of bumper.
1.
To remove the factory bumper, you will need to remove the center plastic insert from the bumper.
There will be several clips that hold it in place. This will allow you to have access to the bumper bolts.
2.
If an Adaptive Cruise Control Module is present, located on the driver side, it will need to be unplugged
and removed. It will be installed later.
3.
Remove the four bumper nuts, two on each frame rail.
4.
Unplug the fog lights if present.
5.
There will be two more nuts, one located on each frame rail that needs to be removed from the
backside of the bumper.
6.
When removing the factory bumper, there will be 3 plastic push pins that will need to be removed from
the top of the bumper.
7.
Remove the factory tow hooks if present.
8.
There is a driver and passenger side bottom bracket. Mount the bottom brackets to the bottom of the
frame and then the tow hooks. Use the factory bolts to install.
9.
If tow hooks are NOT present, use the hex nut tab provided to install the bottom brackets.
10.
Leave the brackets loose enough so that they can be moved to line up the replacement bumper grille
guard.
11.
Mount the Adaptive Cruise Control Module to the Adaptive Cruise Bracket provided. Use the ¼” bolts
provided. You will only use three holes. Mount the bracket to the angle iron that is located on the
underside of the top plate with
16
5
” bolts. The A.C.C. module will face upwards.
12.
Mount the replacement front bumper to the outside of the bottom brackets with ½”x 1½“ bolts. Line
up the bumper from side to side then tighten the bottom bolts to the frame.
13.
Line up the bumper to the truck. The holes are slotted so the bumper can be raised or lowered. It can
also be leaned forwards or back. Then tighten the bolts.
14.
There is a driver and passenger top bracket. Use the factory double bolt-bracket to mount the top
bracket to the frame. Mount the single holed side of the bracket to the outside of the upright. If you
have fog lights, the fog light bracket will mount to the same hole. Use ½“ x 1 ¾“ bolt to install.
15.
Plug in fog light wires and adjust fog lights.
MAKE SURE ALL NUTS AND BOLTS ARE TIGHT!
Содержание BFERF15LD
Страница 2: ...B F E R F 1 5 L D ...
