12
13
14
12 & 13. Once in the open position double check the clamp engagement to the side rail and tighten. Test the
cover again for proper operation, adjust as needed, then tighten the star knobs.
of the truck bed. This can be done by inspecting the area below the bed floor and drilling a 5/8" hole in
the corner of the wheel well OR through an existing hole in the bed, enlarging it to 5/8"- Careful to not
drill too far.
Note:
If you choose to drill holes, be sure to clean up the metal shavings.
Page
5 of 7
CAUTION:
ATTENTION!
Corner of wheel well
Inspect area below bed floor to insure
proper clearance before drilling
Before drilling for drain tubes,
verify area is free and clear of
obstructions below the truck bed.
Operating Drilling Locations:
1
1
