Photo 9
8.
This step will require the use of a T25 Torx bit and driver. You will be removing two Torx screws from the rear roll
bar and re-installing them back into the same holes. Locate the two center cutouts on the rear of the Roll bar.
See
Photo 7.
9. Using a T25 Torx, remove the two Screws located in these cutouts and place them through the two rear strap holes
attached to the top,
See Photo 8 & 9.
10. With the rear straps threaded through the rear buckles, tighten the straps.
After installing the two rear straps, it may be necessary to adjust the other straps to take out any wrinkles. The two rear
straps mounted to the center of the rear roll bar are designed to keep the rear portion from excess flapping while driving
and to make sure your top remains tight.
Removal or Reinstallation of the Freedom Panels
Photo 1
Photo 2
Your mesh top has been designed to remain on the vehicle when you re-install your hard top and Freedom Panels.To
remove or re-install your hard freedom panels, undo the hook and loop on the rectangle loop and strap installed on the
sound bar in step #7 to put your hand behind the mesh
(Photo 1 & 2)
. lock the latches and reinstall the hook and loop
on the sound bar strap. Repeat on the other side.
Photo 7
Photo 8
