Rottler SG9M, Руководство по эксплуатации и обслуживанию, Страница: 10 / 72

Introduction/Safety/Installation 7 SG9M Manual
Air Adjustments:
Float:
The float regulator is located at the rear of the spindle base on the bottom of the interconnect box.
If the machine is not floating properly, it could be from too much or too little air from the regulator. Turn
the regulator all the way off (full counter clockwise). Start turning the regulator slowly clockwise while
continually checking the Work Head for proper floatation. Once the correct float is established, lock the
regulator into place by pushing in on the blue adjusting knob.
Use as little air as possible to achieve correct floatation. Using too much air will could cause
the spindle base to move slightly to the right when going into tilt. This will cause a scratch up the side of
the cylinder.
Power Supply :
This machine has the following power requirements:
208 to 240 VAC it shut not exceed 240 Volts
Single Phase
50 or 60 Hertz
30 amps
See illustration below for correct connection of “measured” incoming power. connect single phase wiring
to the main rear enclosure, located on the right rear of machine base. The connection point for power is
located inside the enclosure. The connection termination point is located on the left hand side of the
electrical panel about half way up. Connect L1 to the grey terminal block, L2 (neutral) to the blue terminal
block and shop ground to the green and yellow terminal block. Attach wire from the grounding rod to the
second green and yellow terminal.
Important:
Electrically connect in accordance with national and
local electrical codes.
Grounding:
This machine must be connected to a good earth
ground rod. A 6 foot, ½” diameter, 15 OHM, Copper
grounding rod driven into the earth next to the
machines is preferred. Not providing a grounding rod
could void factory warranty.