Rottler SG10XY, Руководство по эксплуатации и обслуживанию

Страница: 13 / 146

INSTALLATION REPORT
SG10XY
REV 062718
OFFICE USE ONLY
Route to: Servicer Mgr Accounting Andy Accounting Warranty Exp Date ________
ROTTLER MANUFACTURING MUST HAVE THIS REPORT RETURNED
TO PROPERLY QUALIFY WARRANTY ON EQUIPMENT
Customer:____________________________ Address:_______________________________________
City:_________________________________ State:_____ Zip:_________ Phone:_______________
Country:______________________________
Machine Model:___________ Serial Number:__________ Representative:________________________
MACHINE INSTALLATION: Electrical information MUST be complete to validate this report.
Customer is responsible for providing electricity to machine in a manner that meets the local
electrical code requirements.
______Check machine level for equal support on feet.
______This machine requires between 208 and 240 Volts AC, Single Phase, 50/60 Hz, isolated power
supply. Measure the incoming voltage between L1 and L2. Current requirements for this machine
are 30 amps. Measure the incoming AC voltage at least twice during installation.
1) __________VAC 2) __________ VAC
______Measure each leg of the incoming supply to ground. When using a one leg and neutral of a 380
VAC three phase supply L1 should measure 240 VAC and Neutral should measure almost 0 VAC.
L1 to ground _________VAC L2 to ground __________VAC.
Make sure all electrical equipment has the proper overload protection. The SG10XY should have a fully
isolated power supply to prevent damage and uncontrolled movement of the machine. If the SG10XY is
on the same power lines that are running to other electrical equipment (grinders, welders, and other AC
motors) electrical noise can be induced into the SG10XY electrical system. Electrical noise can cause the
controller to see false signals to move.
Neutral and machine ground are not the same thing. You should measure an
open circuit between Neutral and ground.
IF VOLTAGE IS OUTSIDE THE CORRECT RANGE AT ANY TIME THE
MACHINE WILL NOT OPERATE PROPERLY AND MAY BE DAMAGED.
______ BEFORE turning power on to the machine. Check all wires for security by using the correct screw
driver and turning CW until movement stops. Stranded wire can “spread” slightly from vibration
during transport.
______Install electrical component covers inside the electrical enclosure with fasteners provided.
______Air of the proper pressure and capacity connected to the machine. Air supply must be free from oil
and water. Oil or water will damage electrical and air components. Air pressure should never drop
below 90 PSI at any time. Failure to provide adequate air supply may cause improper floating and
clamping.
______Remove all shipping brackets in accordance with the machine manual.
______Clean any rust inhibitor from the machine surfaces. Slide the spindle base from side to side
continually cleaning the machine base until all inhibitor is removed.
______Have the operator read through the operation manual before training begins. This will help him
be familiar with the button pushing sequences. Have the operator read through the manual again
after training and some of the sequences will make more sense.