Rottler F103 Series, Руководство по установке, эксплуатации и обслуживанию

Страница: 203 / 318

Section 6 Maintenance F103/4/5A Manual
www.rottlermfg.com
6-16
Magnescale Indicator Set Up
--Turn off power to Magnescale by unplugging the connector on the back of the unit. Or having someone
else shut off the power while you stay in front of the unit.
-- Plug it back in while you are holding down the reset button. You will see either “mm” or “in”
-- While the still holding the reset button down, press the mode button and both the “mm” or “in” will start
blinking, you are now in edit mode.
-- You can now release the reset button, use the up arrow to switch between “mm” and “in”.
hit the set button to lock in the selection
Setting Up Sensor Stroke Depth.
Press and hold set and mode until options menu starts blinking. Push mode once to switch to rSLP and
then press up arrow to set +.0005.
-- Push set once, and then mode ONE time, then rSL should be blinking
-- Press and hold set and mode until options menu starts blinking. Push mode once to switch to rSL and
then press up arrow to set +.0002.
-- Push set once, and then mode button.
-- should be set to rEF > OFF
-- Push mode button once.
-- Should be set to E_St > St
-- Push mode button once. You should be back to the main readout screen
--Depress the plunger it should go from zero to max of .2000-2500