Page 11
4.
Press the GATE UP/DN button.
A beeper will sound as the rear gate rises.
When the gate is up, the beeper will stop and the GATE UP light will turn on.
5.
Press the FLOOR BACK button.
The floor will start moving towards the beaters. The screen will read:
After a few seconds, it will change:
A. Adjust the speed of the floor by pressing the
FLOOR INCR (+)
and the
FLOOR DECR (-)
buttons. The FLR percent value on the screen will change:
B. Stop the floor by pressing the
STOP/ALARM CLEAR
button. To restart the
floor motion press the
FLOOR BACK
button.
C. When the floor reaches the back limit, an alarm notification will appear on the
screen and the control unit will start beeping:
To clear the alarm press the
STOP/ALARM CLEAR
button.
6.
Press the FLOOR FWD button.
When the button is pressed the screen will read:
The floor will come towards the truck cab. The beaters will ramp down to a halt and the BEATER ON
light will turn off.
When the floor reaches the front limit, the rear gate will lower.
The screen will read:
7.
Repeat the cycle of steps 3 to 6 as needed. When you are done:
Press the SYSTEM ON/OFF button.
Shut down the PTO and the truck.
PRESS GATE UP
TO OPEN GATE
OK TO SPREAD
PRESS FLR BCK PB
SPREADING
PRESS FLR BCK PB
R: 0 0 FLR
P: 5828 5828
26%
OK TO SPREAD
PRESS FLR BCK PB
**FAULT DETECT**
FLOOR STOPPED!
OK TO SPREAD
PRESS FLR BCK PB
FLOOR FORWARD
FLR SPEED = 100%
PRESS BEATER ON
TO START BEATERS
R: 0 0 FLR
P: 5828 5828 25%
Beater RPM
Beater Pressure
