ENGLISH
19
Status-LED:
The light from a status LED on the left earpiece will be visible when the headphones are on. The
following statuses are possible:
LED-Status
Significance
3 x blue
During switching on
Alternating blue / red
Bluetooth is searching for the ROLeak Aqua 3Plus
Regularly blue, every 3 seconds
Connection with the ROLeak Aqua 3Plus has been
established
Continuously red, then off
During recharging until the battery is full
Briefly red, then off
During switching off
Switching on / Switching off:
Switch on by pressing the I/O button on the headphones until you hear a signal tone. The status
LED flashes blue three times, then alternates between red and blue light to in-dicate that the
headset is searching for the Bluetooth partner device.
The status LED on the headphones will start to regularly flash blue every 3 seconds as soon as
the switched-on ROLeak Aqua 3Plus has been detected.
The search for the Bluetooth signal from the ROLeak Aqua 3Plus will continue for 5 minu-tes.
The headphones will switch off if the device is not detected during this period. The status LED
will go out.
Switch off by pressing the I/O button on the headphones down until the red status LED lights up
and goes out afterwards.
Volume:
The headphones volume can be adjusted over 15 levels. It can be set using the V+ / V- buttons
on the headphones or the
and
buttons on the ROLeak Aqua 3Plus.
Pairing:
"Pairing", i.e. the initial connecting up of the ROLeak Aqua 3Plus with the supplied headphones,
has already been carried out in the factory. The ROLeak Aqua 3Plus is al-ready saved as a
"connected device" in the data memory in the headphones. The two devices will find and con-
nect themselves up automatically after being switched on.
Battery:
The headphones are powered by an internal battery.
A warning signal will sound when the battery is low. The headphones will switch off a few
minutes later without another warning.
Use the recharger provided in the package for recharging. It connects up to the headphones via
the USB socket
and it also connects up to the general power supply. Alternatively, the
headphones can be connected to a computer or USB power supply via USB cable for recharg-
ing. The status LED will be red during recharging. It will go out as soon as the battery is fully
charged.
The integrated battery is not replaceable.
Do not open the device. Contact your service partner if you have battery problems!
7.1
Using a different Bluetooth headset
You can also use different Bluetooth headphones instead of the headphones supplied by us.
You can do this by connecting up the ROLeak Aqua 3Plus with the new headpho-nes (so-called
"pairing").
Proceed as follows to run a pairing process:
The ROLeak Aqua 3Plus must be switched off.
