12
ENGLISH
Regularly check extension cords and replace them if they are damaged. Keep the handles
dry, clean and free of oil and grease.
15
Pull the plug from the socket.
When not using the electric tool, before maintenance or
when changing tools, such as saw blades, drills and cutting bits.
16
Do not leave any tool keys inserted.
Before switching on, check to see that keys and ad-
justment tools have been removed.
17
Avoid unintentional activation.
When plugging the tool in, make sure that the switch is
turned off.
18
Use outdoor extension cords.
When outdoors, use only extension cords that are approved
and appropriately marked.
19
Be alert.
Pay attention to what you do. Approach your work sensibly. Do not use the electric
tool when you are distracted.
20
Check the electric tool for damage.
Before using the electric tool, you must inspect safety
equipment or slightly damaged parts carefully to ensure that they work properly and as in-
tended. Check to see that the moving parts operate freely and don't stick, and to make sure
no parts are damaged. All parts must be mounted properly and meet all the conditions for
ensuring trouble-free operation of the electric tool.
Damaged safety equipment and parts must be properly repaired or replaced by a profes-
sional facility, unless otherwise indicated in the user manual. Damaged switches must be
replaced by a customer service facility.
Never use an electric tool whose switch cannot be turned on and off.
21
Caution.
Using other insertion tools and accessories may cause injury.
22
Have your tool repaired by an electrical expert.
This electric tool meets applicable safety
requirements. Repairs must be made only by an electrical expert using original replacement
parts. Otherwise accidents many occur.
1.3
Special safety instructions
Store these instructions in such a way that they are accessible at all times for operating
personnel!
In addition to these operating instructions the following documents of related components and of
the pumping media should be applicated technical specifications , material safety data sheets,
operating instructions.
The manufacturer shall not be held liable for damage resulting from non-adherence to the
operating instructions!
Danger of death due to electric shock!
Prior to work on the pump, always disconnect the drive from the power supply.
Danger of death due to explosion!
Do not pump any liquids with a flash point of less than 55°C. Do not pump petrol or
solvents.
Danger of scald burn due to high media temperature!
Fill the solar system only when cold – if necessary cover the solar collectors.
Danger of burn due to hot motor casing!
Do not block neither suction nor pressure hose more than 1 minute to avoid overheat-
ing of the motor.
Danger of injury due to splashing liquid!
Connect the hoses tightly to the pump.
Material damage due to dry running!
Never allow the pump to run dry for more than 1 minute.
Material damage due to tilting of the cart on uneven ground!
Operate the filling unit only on even ground.
