GB
37
Navigation through the menu
Temperature scale
Calibration
Menu settings
In addition to the primary functions described above the control panel can be used to
navigate through the menu.
- Press the left softkey
to access the menu. Navigation though the menu is done with
the control panel
- Use the directional keys displayed red on the previous page to navigate through the
menu.
- Browse through submenus by pressing the
button.
- To save the changed setting leave the menu by pressing the left softkey
.
- To leave the menu without saving press the right softkey
.
The temperature scale can either be set manually or the imager can determin eit
automatically based on the measured extreme values.
- On the start screen press the
button to switch from automatic
to manual
temperature scale mode. The imager copies the automatically determined extreme
values into the manual temperature scale mode.
- Press the
button for 2 seconds to enter the manual mode menu. Set the lowest
value of the scale using the right/left buttons (
/
) on the control panel.
- Use the up button
to select the highest value and adjust it using the right/left buttons
on the contorl panel.
- Save the settings using
Ok
.
The imager is self calibrating regularly. To calibrate manually push the ON/OFF switch at
any time.
This chapter describes the possible settings in the menu point by point. All menu points
can be entered, adjusted, saved and discarded as described in the chapter "Navigation
through the menu". In-depth explanation of basic principles can be found at the end of
this manual.