rothaudio.co.uk |
7
USeR MANUAL
enGLISH
flush Wall mounting Instructions:
Please note: the hanging methodology employed with this product is intended for mounting on
walls of standard construction, which includes most residential and business office environments.
Such environments are constructed with wooden studs behind the walls that will securely accept the
enclosed screw. If you do not notice resistance behind the wall when drilling the pilot hole you probably
do not have a stud in that location and will then need to use the enclosed wall anchor.
tools required:
Number 2 Philips head screwdriver bit or hand screwdriver.
Drill - electric or cordless, with 3/32” & 1/4” bits.
Wall mounting Instructions:
1. Place the cardboard Wall Mount template on the wall, oriented horizontally, at the desired
Soundbar mounting location.
2. Make small marks on the wall at each of the four bracket screwhole locations. Remove the
template from the wall.
3. Using a drill with a 3/32” bit if mounting into a stud, or a 1/4” bit (and then inserting the included
wall anchors. where there is no stud, drill a 1 1/2” deep pilot hole at each of the mounting
screwhole marks on the wall. Pre-tapping the wall with a nail or punch will ensure a better grip for
the drill bit as it enters the wall.
4. Place the mounting bracket on the wall lining up the mounting screwholes of the mounting bracket
with the holes on the wall. Screw the mounting screws fully into the wall anchors or stud. Be sure
the screws are inserted straight (perpendicular with wall and parallel with floor. and are securely
mounted. the mounting bracket should now be securely attached to the wall. Repeat the above for
the second bracket.
5. Position the Soundbar over the mounting brackets and guide the two bracket ‘heads’ into the
cutouts in the rear of the Soundbar. Slowly lower the Soundbar approximately 1/2” until it comes to
a rest. the Soundbar should now be secure.