33
Communicator
|
3.05
6.4 RF Connection
The following sections detail how to set up an RF connection to the controllers.
•
Option A with Platinum RF (RCLP-RF)
•
Option B with Platinum RF Remote
6.4.1 Option A with Platinum RF (RCLP-RF)
6.4.2 Option B with Platinum RF Remote
Install and wire the base RLINK to the Communicator External Box. Disconnect the base
RLINK's power before beginning the following procedure.
Install the remote RLINK.
1. In the Communicator unit, go to
System > Advanced Setup > RF/Wired Network
.
2. Configure the settings as required (refer to Configuring the Channel Settings, page 27 for
details).
3. Apply power to the base RLINK.
4. Disconnect the Communicator's power.
5. Apply power to the Communicator:
o
In
new installations
, perform a
Cold Start
.
