25
-- 7) INSTRUCTIONS FOR MACHINE USE --
Specialized personnel are not required for the operation of this compressor,
however it is essential that the operation personnel have read the manual and that they
can put into practice all the instructions and advice provided.
It is only necessary to use specialized personnel for special maintenance
operations, and those with the necessary technical know-how as provided by the "Rotair"
assistance service.
-- 7.1) BEFORE STARTING UP THE MACHINE --
Before starting up the machine carefully proceed according to the following instructions:
-7.1.1)
Make sure that the machine is level; using the support foot or wheel; an
inclination of over 15° is not permitted;
-7.1.2)
Check that the electric wires are connected to the battery terminals; when
making connections always take the greatest care to ensure that the cable which
comes from the starter motor is connected with the positive pole (+) of the battery
and that the wire connected to earth is connected to the negative pole (-) of the battery;
-7.1.3)
Check the motor oil level; refer to the instructions contained in the use
and maintenance manual as concerns the type and quantity of lubricant to be used
enclosed with this machine documentation;
-7.1.4)
Check the compressor oil level: this operation must be undertaken no sooner than
5 (
five
) minutes after the machine has been stopped, this is in order to permit the lubricant
in circulation to completely flow
into the oil separator tank.
- Before unscrewing the cap of the
filler (Fig. 8 part A) to which the
graduated level rod is fixed make
sure that the system is no longer
under pressure (
the manometer
should indicate 0 bar
)
- Remove the cap and clean the
level indicator rod
- Tightly screw back the filler cap
and then re-extract it to ensure
that the lubricant level is between the two notches (minimum level and maximum level) on
the rod.
- if necessary add the required amount of oil: the level must
never
exceed the maximum
level notch.
- Use only the oil types indicated in paragraph 2 (Technical data).
A
Fig. 8
Содержание MDVN 71 AP
Страница 2: ...2...
