INSTALLATION
Switch Template A
(Actual size)
WIRING HARNESS INSTALLATION
SWITCH INSTALLATION: F
IGURES
5 & 6
1. Remove side scuff plate and kick panel.
2. Starting at the scuff plate, route three pin pump connector end of harness
under carpet to exit through opening under the seat, and connect to pump.
For seat mount switch connect three pin switch connector end of harness to
switch. (If no carpet opening, create as required.)
3. Route three pin switch connector end of harness under carpet to console
and connect to switch (For console mount switch).
4. Wrap foam adhesive around switch connection to prevent rattles.
5. Route red (power) and black (ground) wires along scuff plate, under carpet,
toward fuse panel.
6.
F
OR POWER
, cut the red wire on the extension harness to desired length and
solder
OR
use attached butt splice to fused harness, also solder the other
end of fused harness to a positive Accessory fuse (fused 5 Amp or greater)
OR
Insert the red wire with special terminal from fused harness assembly to
a +12V Accessory fuse (fused 5 Amp or greater).
F
OR GROUND
, cut the black wire on the lumbar harness to desired length,
install ring terminal supplied and attach to a ground point.
OPERATION AND TROUBLESHOOTING
OPERATION PROCEDURES
OPERATION
:
The switch is used to operate the system. If your lumbar system was installed correctly, it
should perform as indicated below.
INFLATE/DEFLATE
:
To inflate the bladder, depress the high side of switch. The pump motor will continue
pumping air until bladder maximum is reached, then overflow will vent out through the
pump system.
To deflate bladder, depress the low side of the switch, and with your body weight pres-
sure, the bladder will vent out the air as long as you hold the switch.
P
AGE
6
