Rosslare SA-23-B4, Инструкция по установке и эксплуатации, Страница: 3 / 4

3
6. Using the SA-23
The AY-L23 is used along with either the SA-23 2-button or 4-button
remote control.
The SA-23-B2 remote is programmed to:
 Button 1 – Wiegand output to A DATA0/1 with A FET(relay)ON 5S
 Button 2 – Wiegand output to B DATA0/1 with B FET(relay)ON 5S
The SA-23-B4 remote is programmed to:
 Button 1 – Wiegand output to A DATA0/1 [ID number]
 Button 2 – Wiegand output to A DATA0/1 [ID 1]
 Button 3 – Wiegand output to A DATA0/1 [ID 2]

Button 4 – Wiegand output to A DATA0/1 [ID 3]
6.1 Initial Setup
To set up the remote for use:
1.
Install the battery.
The red LED turns on for 1 second, turns off 1 second and then
turns on for 1 second.
2. Check the distance range of the remote:

If the distance is set to long range (70 m), LED flashes on and
off 0.5 seconds 3 times.
 If the distance is set to short range (15 m), LED flashes on and
off 0.1 seconds 6 times.
By default, the remote distance is set to 70 m.
6.2 Changing the Remote Distance Range
You can set the remote range to either 15 or 70 m.
To set the remote distance:
1.
Remove the battery from the remote.
2. Press any button to reset the remote.
Any time you remove the battery from the SA-23, you must reset
the remote control by pressing any key to discharge the internal
capacitors.
3. Install the battery.
4. Press 1 and 2 together before the LED flashes for a second time.
The remote toggles to the other remote distance range.
 If the distance is set to long range (70 m), LED flashes on and
off 0.5 seconds 3 times.
 If the distance is set to short range (15 m), LED flashes on and
off 0.1 seconds 6 times.
6.3 Changing the ID of Button 2 (for SA23-
B2 only)
You can set Button 2 to transmit the same ID as Button 1 or to
transmit a unique ID. By default, Buttons 1 and 2 transmit the same ID
number.
To change the ID of Button 2 to be unique:
1.
Remove the battery from the remote.
2. Press any button to reset the remote.
3. Press 2 and install the battery until the red LED flashes quickly 5
times for 0.1 seconds.
Button
2 will now use transmit a unique ID (ID of Button 1 +1)
4. Close the cover.
To change the ID of Button 2 to use ID of Button 1:
1.
Remove the battery from the remote.
2. Press any button to reset the remote.
3. Press 1 and install the battery until the red LED flashes quickly 5
times for 0.1 seconds.
Button
2 will now transmit the same ID as Button 1 .
4. Close the cover.