Installation
10
AY-V12B Installation Manual
The reader must be mounted with the appropriate screws (not
supplied), as described in the template provided.
To install the reader:
1.
Determine an approximate location for the installation of the
reader.
2.
Peel off the back of the self-adhesive installation label template
and locate it at the required location.
3.
Using the template as a guide, drill two holes (the size of which
are indicated in the template) to install the reader onto the
surface.
4.
Drill a 10-mm (
7
/
16
”) hole for the cable. In the event that you are
installing the reader on metal, place a grommet or electrical tape
around the edge of the hole.
5.
Route the interface cable from the reader to the controller. A
linear type power supply is recommended.
The reader can also be mounted using strong epoxy glue. After
application, the reader should be firmly held in place until the
glue dries.
