10. Refer to Figure D. Match the bottom of the container to the allotted slot on the shelf base. Push down to snap in place.
11. Once the container is latched firmly onto the base, turn the whole -------- Figure D
-------
thing over so you see the underside of the shelf base. Here, you will
see 2 slots for screws. Install the screws (1) provided, then turn the
container right side up.
12. Lock the shelf base (j) into position by sliding the back portion
under the affixed bracket. Use the arrow in Figure E as a guide.
1
,---..�cc1
2
13. On the bottom side of the false chamber (c) is a lip that
folds outward. Slide the false chamber smoothly into the container,
lip-side first. Make sure that the lip touches the inner side of the
container's front panel.
14. If you wish, you may pour in the contents into the container at this time. Fill
the false chamber first, then the body. Securely place the lid (a) on top.
15. Hook the funnel (h) onto the container by connecting the inner nubs to the
notches on the container's spout.
16. You have two options for label placement:
• Print your label on regular paper and cut to size (3.1" x 5.25" / 78.75mm x 133.35mm).
Place it under the curved label holder (e), with the printed side directly on the plastic piece.
Snap the label holder onto the assembled unit using the allotted ridges. The side edges should latch snugly onto the
front of the container, right above the handle.
• Print your label on sticker paper and cut to size (2" Diameter/ 50.8mm Diameter).
17.7"
449.6mm
Peel and stick it onto the flat side of the plastic knob (g) and install the prepared
!.�
piece onto the metal handle by pushing it through the notches in the middle.
..
----·-·t·i:··=============:::i
Your dispenser unit is now ready for use! Enjoy!
PRODUCT SPECIFICATIONS---------
Container Capacity: 3.5 gallons per unit
Assembled Product Weight: 7 lbs
* Also available with table-top leg (DSlOO) and bamboo shelf base (DS102)
21"
533.4mm
...
CARE INSTRUCTIONS-----------------
1. To maintain the quality of your EZ-SERV
®
Multi-System dispenser, wash all parts regularly in warm soapy water. Use a
non-abrasive sponge.
2. DO NOT put any part of the unit through any dishwasher or dryer machines.
3. When disassembling the container, handle all parts gently. Please refrain from using too much force.
4.
To keep the handle polished, you may use a commercial metal cleaner - however, remember to only use this on the
outer portion and NOT on the shaft.
5.
Reassemble the unit only after all parts are completely dry.
2014
June
23 IS031 - Vl
