Ross VTA-8060, Руководство пользователя

Страница: 19 / 28

BNC Labels
Affix the supplied BNC label, as per the included instructions, to the BNC area on the rear of the rack
frame.
Cable Connections
The following diagram provides instruction for connecting input and output coax cables to the VTA-
8060 when mounted in RossGear 7200 series Video, and 7850 series A/V distribution frames.
It is recommended that all unused outputs be terminated. The specifications in this manual are based
on all outputs being terminated.
1. Connect the external video input to be compensated to the appropriate DA rack
frame BNC looping input connector. Terminate the unused connector.
2. Connect the output cables that you require to BNC outputs 1-6. Be sure to terminate
any unused outputs 1- 4. Do not terminate outputs 5 and 6 if not used.
3. Assemble two coax cables long enough to connect the rack frame to the control
modules. Prepare enough cables for each Truck Amp installation.
4. Connect coax cables to BNC outputs 7 and 8.
5. Run the coax cables to the equipment rack where the Truck Amp panel will be
installed.
6. Connect the coax cable that is connected to the DA rack frame BNC output 8 to the
Gain (upper) BNC output of the module. See Figure 4 and 7.
7. Connect the coax cable that is connected to the DA rack frame BNC output 7 to the
Equalization (lower) BNC output of the module. See Figure 4 and 7.
Figure 8. VTA-8060 Cabling Designations for RossGear 7200 and 7850 Series Frames
VTA-8060 User Manual (Iss. 01A) Installation and Setup
•
2-7