Ross Ultricool, Руководство пользователя

Страница: 14 / 36

14 • Hardware Overview Ultricool User Guide (v1.0)
Rear Panel Overview
The rear panel provides a support structure for connecting power inputs, power outputs, and to your facility
network. This section summarizes the Ultricool rear panel features.
Figure 3.2 Ultricool — Rear Panel (Duct Removed) Overview
1. Fans 5-8
Fans 5-8 draw air into the Ultricool and if the duct is installed on the rear panel over these fans, directs the air
down and to the right of the chassis.

When shipped from the factory, a duct is installed over fans 5-8. This duct can be removed entirely or installed
over fans 1-4.
2. PWR Ports 1, 2
There are two power supply connectors located on the rear of the Ultricool. Each connector requires a 15VDC
connection to an external power supply.
The Ultricool ships with one power supply. An option is available to order a second power supply for
redundancy.
3. ALARM Connector
The ALARM connector is a general purpose output that provides contact closure alarm state monitoring. Refer to
the section “
Using the ALARM Connector ” on page 17 for details.
4. ENET Port
The ENET port is an RJ45 connector used to connect the Ultricool to an external Ethernet network. This port is
required for monitoring and control of Ultricool.
5. Fans 1-4
Fans 1-4 draw air into the Ultricool and if the duct is installed on the rear panel over these fans, directs the air
down and to the left of the chassis.
1) Fans 5-8 3) ALARM Connector 5) Fans 1-4
2) PWR Ports 1, 2 4) ENET Port
Notice
— The Ultricool automatically powers on when power is applied.
Notice
— The ENET port does not provide Power-over-Ethernet (PoE).
ENET
±15VDC
max.60W
NO
ALARM
C NC
PWR 2
PWR 1
5
6
7
8
1
2
3
4