Ross SYNERGY 4000DR-003, Руководство по эксплуатации, Страница: 290 / 332

9–10 • Custom Controls Synergy Series Operation Guide (v18)
Programming a Relative Custom Control
Use the following procedure to program a relative custom control button with basic functions:
1. Set up your MLE re-entry configuration to record the relative custom control at the
Re-entry level you want.
2. Navigate to the Custom Controls Menu as follows:
• Press
HOME B Custom Controls
.
Custom Controls Menu
3. Select the Custom Control bank and button that you want to record to as follows:
• Use the Bank knob to select the custom control bank that you want to record the
custom control on.
• Use the
Button
knob to select the custom control button that you wish to program.
You can also press the button directly on the panel.
4. Press Start Relative Recording to display the Recording Menu .
5. With the recording in progress, press the buttons on the control panel that you would like
to have played back, in order. All subsequent keystrokes will be remembered, in the
exact order that you press them .
6. Insert any special functions you want as follows:
• Press
Insert Special
to display the Insert Special Menu 1-2 .
• Insert functions as outlined in the section “ Programming Special Functions ” on
page 9–11.
7. Press
Finish Recording
, or the flashing custom control button, when you have
finished recording the macro.
You will notice an “at symbol” ( @ ) next to the custom control you just recorded,
indicating that this relative custom control contains information.
Note You must record a relative custom control on an MLE that is re-entered
onto the PGM/PST MLE for it to run properly.
Note Buttons with an “at symbol” ( @ ) next to them in the list are already
programmed with a relative custom control, however, they can be
overwritten or edited. Refer to the section “
Editing Custom Control
Macros ” on page 9–20 for more information.
Note Press Cancel Recording to terminate the programming procedure.
The macro will not be recorded.