Ross SYNERGY 4000DR-003, Руководство по эксплуатации, Страница: 254 / 332

8–12 • Memory Functions and More Synergy Series Operation Guide (v18)
Storing Registers with DVE Crosspoints
When you store a memory register for an MLE that includes a DVE effect, you also automatically
store the DVE’s associated Aux Bus crosspoints that are used to route input sources to the DVE. To
store the DVE effect and its associated Aux Bus crosspoints, the following important prerequisites
must be fulfilled:
• A primary DVE must be connected to the switcher.
• The DVE effect number (that you wish to store) must be recalled immediately prior to
storing the full effect to memory.
• The Aux bus must be assigned to the DVE.
Once stored, the effect and its Aux Bus crosspoint can be recalled by pressing the
INCL DVE
button
as part of the recall procedure. Refer to the section “ Recalling Memory Registers ” on page 8–12 for
instructions.
Notes on Storing Registers
Please note the following important points:
• Whether you are using a “ 1+0 DVE ” or a “ 1+1 DVE ”, any Aux Bus outputs can be used
to connect the primary DVE’s video and key channels. For definitions of the above
terms, refer to the section “
Documentation Terms ” on page 1–5.
• Any Aux Bus can be associated with a secondary DVE, but you cannot store secondary
DVE effects.
• When a primary DVE effect is recalled, the Aux Bus associations with any device will
also be recalled. Aux Buses not associated with devices (as determined during
installation) will not be recalled under any circumstances.
• All Aux Bus - to-DVE associations are performed during switcher setup. Refer to the
section, “ Aux Bus Setup ” in the Synergy Series Installation Guide , for more
information.
Recalling Memory Registers
This section provides instructions for recalling memory registers from two locations on the Synergy
switcher:
• Recalling registers using the Global Memory System Group
• Recalling registers using the MLE Memory Group
The procedure is very similar to the storage procedure; however, you have several options for the
“type” of data that you wish to recall. The following two sections provide instructions for each recall
situation.
Recalling Registers using the Global Memory System
For all Synergy switchers, use the following procedure to recall switcher memory registers using the
Global Memory System Group :
1. In the Global Memory System group’s Recall Section , select the MLE (or group of
MLEs) that you wish to recall.
• To enable all MLEs for the next recall operation, press ALL .
• To recall just one MLE, press the button for the desired MLE.