Ross SYNERGY 4000DR-003, Руководство по эксплуатации, Страница: 250 / 332

8–8 • Memory Functions and More Synergy Series Operation Guide (v18)
6. Include Section
The Include Section governs what specific category of information is recalled to the
panel when a memory register is recalled.
• When lit,
ATTRIB
indicates that the Auto Recall option in the Personality menu is
enabled, and the switcher will recall the Key Only and Effects Dissolve settings as
part of a memory recall operation.
• Enable
INCL DVE
to recall the DVE effect number (if any) that was stored in the
selected memory register.
~
When lit, the next recall operation is “armed” to recall the DVE effect
associated with your primary DVE into the selected MLE. The button stays on
until turned off manually.
~ When off, all data except for the DVE effect will be recalled to the selected
MLE. This function allows you to retain a selected DVE effect, yet recall a
memory register into the MLE.
Refer to the section “ Understanding DVE Send Operation ” for more information.
• Press
VTR CLIP
to recall clips (segments) from a selected serial controlled device
that is connected to Synergy via RS-422 communications. Devices include VTRs,
Video Servers and Audio Servers. The
VTR Remote Control , Video Server
Control or Audio Server Control option must be installed, respectively. Any
combination of options can be installed. Refer to the section “ Clip Control
Overview ” for instructions.
7. Disk Drive
The Disk Drive is used to store and recall six categories of switcher registers, using a
standard 1.44 MD high-density floppy disk or USB key.
• Memory Registers are “snapshots” of the various MLEs.
• Custom Control Registers are the functions that you have programmed into the
switcher’s Custom Control Group , such as VTR and DVE remote control
commands.
• Personality Registers are user-configurable registers that apply to your particular
style of operation. Data such as DSK Setup and Favorite CG Setup is stored here.
• VTR Clip Registers store VTR clip register information (in timecode format).
• Installation Registers store all of the setup and configuration settings for the
switcher.
• 3D Sequence Registers store all of the S&T 3D sequences.
Refer to the section “ Working with Storage Devices ” on page 8–24 for instructions on
saving and recalling Memory , Personality , VTR, Custom Control , and 3D Sequence
Note If you have the USB Removable Media Drive option installed, the
floppy disk drive will be replaced with a USB port. The information in
this section is still applicable when using a USB key.
Caution Do NOT remove the floppy disk or USB key from the switcher before
the LED on the disk drive or USB port goes out. Doing so may destroy
the data on your floppy disk or USB key, as well as the data on the next
one you insert into the switcher.
ATTRIB
INCL
DVE
VTR
CLIP