Ross SYNERGY 4000DR-003, Руководство по эксплуатации, Страница: 248 / 332

8–6 • Memory Functions and More Synergy Series Operation Guide (v18)
~ Bank 3 (registers
30
to
39
)
~ Bank 4 (registers
40
to
49
)
~ Bank 5 (registers
50
to
59
)
~ Bank 6 (registers
60
to
69
)
~ Bank 7 (registers
70
to
79
)
~ Bank 8 (registers
80
to
89
)
~ Bank 9 (registers
90
to
99
)
Pressing
BANK
essentially advances the 10’s digit:
~ You can press
BANK
repeatedly, to advance by one bank per press . (For
example, pressing
BANK
,
BANK
would change register
21
to
31
, then
41
.
~ You can also press and hold
BANK
, then press the number of the desired bank
to go directly to that bank. (For example, press
BANK
,
4
, to select bank four).
Refer to the section “ Storing Memory Registers ” on page 8–9 and the section
“ Recalling Memory Registers ” on page 8–12 for memory function instructions.
• Press
ENTER
to conclude all numeric entry procedures such as storing memory
registers, entering transition rates, fade rates, DVE registers and VTR clips. The
button lights immediately when keypad buttons are pressed to indicate that an entry
is pending. Note that
ENTER
is not required for memory recall functions —
allowing you to quickly press just the bank and desired register — for rapid
recalling of your setups.
4. Store Section
The Store Section allows you to store snapshots of the selected MLEs and enter selected
transition rates. Refer to the section “ Storing Memory Registers ” on page 8–9 for
complete memory instructions.
• (All Switchers) Press
ALL
to enable all MLEs for the next storage operation. The
ALL
button lights. When a bank and register are entered on the keypad, information
is stored into memory from each MLE.
• (All Switchers) Press
MLE 1
to store just the contents of MLE 1 in a memory
register. (Synergy 3 and 4) To store MLE 1 plus another MLE, press the desired
MLE buttons simultaneously, e.g.,
MLE 1 + MLE 3
. (On the Synergy 2, press
ALL
.)
• (All Switchers) Press
MLE 2
to store just the contents of MLE 2 in a memory
register. (Synergy 3 and 4 only) To store MLE 2 plus another MLE, press the
desired MLE buttons together, e.g.,
MLE 2 + MLE 3
. (On the Synergy 2, press
ALL
.)
• (Synergy 3 and 4 only) Press MLE 3 to store just the contents of MLE 3 in a
selected memory register. To store MLE 3 plus another MLE, press the desired
MLE buttons simultaneously, e.g., MLE 3 + MLE 1 .
ENTER
ALL
MLE
1
MLE
2
MLE
3