Ross Synergy 100 MD, Руководство оператора

Страница: 324 / 402

18–8
•
Lighting Synergy 100 MD Operator’s Manual (v7.2 MD-S100)
Working with Multiple Channels
You can apply and adjust lighting effects on two channels at the same time.
Use the following procedure to apply and adjust lighting effects on multiple channels:
1. Navigate to the Lighting Menu as follows:
• Press FLY KEY in the Effects Keyers group.
• Press SEL/DVE + Light to display the Lighting Menu .
2. Press SEL/DVE + Ch1+2 to select both channels.
The following table shows how the Lighting effects behave when working with both channels
selected.
Note
When working with two channels, a quick way to give any lighting
parameter equal values is to adjust the value to 100.0% with both
channels selected. Then you can adjust the parameter to the desired
value for both channels.
Lighting Effects Behavior
Lighting Parameter Scenario Result
Position
Coordinates are the same for
both channels. The values are displayed. The joystick or knobs can
be used to position the light source for both
channels.
Channel 1 and Channel 2
have different light source
positions.
A message is displayed to indicate the values are
different. The values for Channel 1 are displayed.
The joystick or knobs can be used to change the
position coordinates by an equal percentage.
Intensity and Ambient
Light Levels
All values are the same for
both channels. The values are displayed. The knobs can be used to
adjust the levels for both channels.
Luminance Clipping
All values are the same for
both channels The values are displayed. The knobs can be used to
adjust the thresholds for both channels.