Ross Synergy 100 MD, Руководство оператора

Страница: 146 / 402

7–40 • Keying Synergy 100 MD Operator’s Manual (v7.2 MD-S100)
Programming a Favorite CG
This procedure allows you to select a “favorite” CG that you can place on the CHAR GEN1 or
CHAR GEN2 buttons in the Downstream Keyer Group . The feature is designed so that you can
select a “clean” CG in the AUTO SELECT mode, with no Key modifiers enabled.
Use the following procedure to program the CHAR GEN1 button:
1. Press and hold CHAR GEN1 in the Downstream Keyer Group .
2. Select the favorite CG source on the Key Bus .
3. Release both buttons.
This completes the procedure for assigning a source to CHAR GEN1 button. The same procedure is
applied to assigning a video source to the CHAR GEN2 button. The selected CG source will be
stored in memory and will be recalled each time CHAR GEN1 is pressed.
Note
If you have a simple or complex Key type already set up, when you
press
CHAR GEN1
or
CHAR GEN2
, the entire Keyer is cleared. In
addition to the favorite CG, the system will automatically select
AUTO
SELECT
and
KEY MEM
(provided the Auto Select Key with the
appropriate Key Memory values has been set up in the installation).