Ross Synergy 1, Руководство по обслуживанию

Страница: 52 / 240

3–6 • Software Upgrades Synergy 1 and Synergy 100 Maintenance Guide (v16-S1)
5. DIP Switch 4
This 8-position DIP switch has the following system assignments (from left to right):
•
SW1
— Reserved . Leave in the default
Down
position.
•
SW2
— Reserved . Leave in the default
Down
position.
•
SW3
— Panel Type . Works with
SW4, SW5
and
SW6
. Refer to the table on
page 3-6 for details.
•
SW4
— Panel Type . Works with
SW3, SW5
and
SW6
. Refer to the table below
for details.
•
SW5
— Panel Type . Works with
SW3, SW4
and
SW6
. Refer to the table below
for details.
•
SW6
— Panel Type . Works with
SW3, SW4
and
SW5
. Refer to the table below
for details.
•
SW7
— Installation Enable . This switch determines the installation status of the
switcher:
~
Up
: Access to installation features is restricted. When you enter the
Installation Menu , a message alerts you that “ Installation Settings are
Locked .” However, you are permitted to view the menus as usual. Upon
exiting the installation menus, the “ Installation Settings are Locked ” menu
once again alerts you that any changes will be ignored upon exiting the
installation tree.
In this position, the installation Load/Save to Disk menus do not appear in the
menu tree.
~ Down : Installation settings can be changed without restriction. However, upon
exiting the menus, an “ Installation Warning ” alerts you that settings are about
to be changed:
Installation Change Confirmation Menu
DIP Switch 4 Switch Positions
DIP Switch 4 Synergy 1 Position
SW3 Down
SW4 Down
SW5 Down
SW6 Down
Note Place the switch in the Up position when you want to restrict access to
installation menus. For certain facilities, this setting is recommended
once installation is complete.