Ross Synergy 1, Руководство по обслуживанию

Страница: 194 / 240

11–8 • Synergy 1 Panel Maintenance Synergy 1 and Synergy 100 Maintenance Guide (v16-S1)
Replacing the Fader
Use the following procedure to replace the failed fader:
1. Test the fader as outlined in the section “ Testing the Fader ” on page 11-7.
2. Power down the Synergy 1 control panel.
3. Remove the screws on either side of the handle, as illustrated below.
• Once removed, the handle will separate, leaving the fader shaft.
• Set all parts aside for later reassembly.
Location of Screws in the Fader Handle
4. In order to gain access to the failed fader, you must be able to lift the cover of the control
panel off the base.
• Gently flip the control panel onto its side on a clean, flat, static free surface.
• Locate the eleven screws on the underside of the tub.
• Loosen and remove the eleven screws, and set them aside in a safe place.
• Gently place the panel back down on its base.
5. For this next step, ensure you have telephone books, or a similar thick, sturdy object
available with which to support the control panel cover. Use the diagram “ Fader
Assembly — View from Bottom ” for reference.
• Raise the cover and slide the telephone books under the rear area of the side panels
to keep it raised and secure while you work.
• Ensure you have enough workspace to access the fader assembly.
• Position a work light in the control panel tub, if necessary.
Fader Assembly — View from Bottom
6. Disconnect the cable from the circuit board to the Connector/Pot assembly, and note its
orientation.
7. Remove the two nuts that secure the entire fader assembly to the tub, and set them aside
for later reassembly.
Connector and Pot
Nut
Tension Adjustment
Fader Horizontal
Position Adjustment
Nut