Ross SRG-2200, Руководство пользователя

Страница: 55 / 96

SRG-2200 User Guide (v6.0) Upgrading the Software • 55
Upgrading the Software
This upgrade procedure applies to SRG-2200 systems where an Ethernet connection is installed. It outlines the
steps necessary to upgrade the software programmed on the main module.
Before You Begin
Before starting, ensure that you comply with the following requirements:
• Connect the SRG-2200 via an Ethernet cable to your local network;
• A PC, also connected via Ethernet to your local network, with the supplied update program(s) and associated
data file(s) available. Data file(s) should be located in the same folder as the associated update program;
• A power-cycle could be required as part of a data file update. Ensure that the unit is not in service during the
update process.
Table 7.1 lists the applicable files for your SRG-2200.
To upload the Patfiles
1. Ensure that the SRG-2200 is powered on.
2. On your PC, run the
RossSystemUpdate_v#.#.#.#.exe program.
3. Set the IP address and IP Mask to be the same as that of the SRG-2200 itself.
4. Select the
Get Mode
button. The status window should confirm the mode:
“
The device is in APP_mode
” displays in the LDC Display on the front panel.
5. If the SRG-2200 is “
not found
”, check again that all connections have been made, then try repeating the
above procedure after powering the SRG-2200 off, and then resuming from the update program start-up line.
6. If the SRG-2200 still cannot be found, contact Ross Video for further assistance.
7. Select the
Open File
button.
8. Select the relevant *.ata file.
9. Select the
Send to device
button. Upload of file takes approximately 1 minute.
10. The status messages window should confirm that the upload was completed successfully. If not, select
Send to
device
again.
11. Power cycle the SRG-2200.
To upload software files to a SRG-2200
1. On your PC, run the RossSystemUpdate_v#.#.#.#.exe program.
2. Set the IP address and IP Mask to be the same as that of the SRG-2200 itself.
3. Select the
Get Mode
button. The status window should confirm the mode:
Table 7.1 SRG-2200 Files
File Type Description
BootWare
At present, can only be uploaded at the factory.
Patfile
Pattern Files Can be uploaded while the SRG-2200 is in operation.
When complete, a power re-boot is required.
Xilfile
FPGA File Requires that the SRG-2200 is in Bootloader mode.
When complete, a power re-boot is required.
Software
SRG-2200 Software Requires that the SRG-2200 is in Bootloader mode.
When complete, a power re-boot is required.