Ross SRA-8901 Series, Руководство пользователя

Страница: 17 / 40

SRA-8901 Series User Manual (Iss. 02) Installation • 2–3
Installing the SRA-8901
The SRA-8901 can be installed in the OG3-FR series frames using one of the supported rear
modules.The procedure for installing the rear module and card in your OG3-FR series frame is
the same regardless of the card model.
Supported Rear Modules
The Rear Module depends on the configuration you wish to use:
• SRA-8901-4 — The 8322AR-311 Rear Module is required.
• SRA-8901-10 — The 8322AR-312 Rear Module is required.
Installing a Card
You must first install the rear module in the frame and then install the card in the appropriate slot
within an OG3-FR series frame. This section outlines how to perform both tasks.
To install the rear module in the openGear frame
1. Ensure that the OG3-FR series frame is properly installed.
2. On the rear of the frame, locate the card frame slot.
3. Remove the Blank Plate from the rear of the slot you have chosen for card installation.
4. As shown in Figure 2.1 , seat the bottom of the rear module in the seating slot at the base
of the frame’s back plane.
Figure 2.1 Rear Module Installation in an OG3-FR Series Frame (Cards not shown)
5.
Align the top hole of the rear module with the screw hole on the top edge of the frame
back plane.
Notice
— Ensure that you install the SRA-8901 in an OG3-FR series frame. Installing the
SRA-8901 in a frame other than the OG3-FR series frame can damage the card, the rear
module, or both.
Screw Hole
Module Seating Slots