Ross RPPW2600, Руководство пользователя

Страница: 17 / 20

X
17 | P a g e
4) Reinstall spark plug in the reverse order.
PRESSURE WASHER STORAGE:
-If you plan on storing your pressure washer for an extended period of time, the following
steps should be followed:
1) Add fuel stabilizer to fuel tank to minimize the formation of fuel gum deposits during storage.
2) Run engine at least 5 minutes after adding stabilizer to allow it to enter the fuel system.
NOTE: If a fuel stabilizer is not used, all gasoline must be drained from the tank and carburetor to
prevent gum deposits from forming on these parts and causing possible malfunction of the engine
(see instructions on draining fuel below).
3) Drain engine oil from engine as described in “Engine Oil Replacement.”
4) Pour approximately one teaspoon of engine oil through the spark plug hole and pull the recoil
starter slowly until you feel increased pressure which indicates the piston is on its compression
stroke and leave it in this position. This closes both the intake and exhaust valves to prevent
the inside of the cylinder from rusting.
5) Use pressure washer antifreeze to ensure that your pump will not freeze during the winter and
to keep components lubricated for maximum efficiency. See instructions below on (Preventing
Freezing Damage).
6) Cover the pressure washer and store it in a clean, well ventilated
and dry place. Ensure storage area is at room temperature.
*** See in-store to purchase fuel stabilizer or pressure washer antifreeze.
-If you wish to drain the fuel instead of adding fuel stabilizer, please follow these steps:
1) Turn fuel shut-off valve to the “OFF” position, remove drain hex. bolt (A)from the carburetor(B).
2) Now turn fuel shut-off valve to the “ON” position and drain the fuel from the tank, carburetor and
hose.
3) Reposition the carburetor drain hex bolt once the fuel is completely drained.
PREVENTING FREEZING DAMAGE:
s If your pressure washer is subjected to freezing temperatures, damage could occur. This type of
damage
is not covered under warranty. To avoid possible damage, a small amount of antifreeze
can be used.
s Place the unit on its side with the water inlet facing upwards,
pour 1/4 cup of antifreeze into the water inlet.
s Disconnect spark plug wire, and then pull recoil starter several times to circulate the antifreeze in
the pump system. Reconnect spark plug wire.
s It is also important to make sure the wand and all hoses are disconnected and drained of all water
or they may burst.
s When taking pressure washer out of storage, run water through the system until it runs clear.