
GPI-100 User Manual (Iss. 06)
Installation • 2–5
Installing the GPI-100
This section outlines how to install a rear module and card in an openGear frame. Refer to the
section “
” on page 2-7 for cabling details.
Supported Rear Modules
The following rear modules are required when installing the GPI-100:
•
DFR-8310 series frames
— The
MDL-R10
Full Rear Module is required. The GPI-100
is not compatible with the DFR-8310-BNC frame.
•
DFR-8321 and OG3-FR series frames
— The
MDL-R20
or
MDL-R22
Full Rear
Module can be used.
Installing a Rear Module
If the Rear Module is installed, proceed to the section “
To install a rear module in your openGear frame
1.
Locate the card frame slots on the rear of the frame.
2.
Remove the Blank Plate from the slot you have chosen for the GPI-100 installation.
3.
Install the bottom of the Rear Module in the
Module Seating Slot
at the base of the
frame’s back plane. (
)
Figure 2.1
Rear Module Installation in an openGear Frame (GPI-100 not shown)
4.
Align the top hole of the Rear Module with the screw on the top-edge of the frame back
plane.
5.
Using a Phillips screwdriver and the supplied screw, fasten the Rear Module to the back
plane of the frame. Do not over tighten.
6.
Ensure proper frame cooling and ventilation by having all rear frame slots covered with
Rear Modules or Blank Plates.
Screw Hole
Module Seating Slots
Содержание openGear GPI-100
Страница 1: ...GPI 100 VANC to GPIO Trigger Inserter Decoder User Manual...
Страница 6: ......
Страница 8: ...ii Contents GPI 100 User Manual Iss 06...
Страница 14: ...1 6 Introduction GPI 100 User Manual Iss 06...